Brushless Motor Controller Driver Board 500W (DC 12V-36V) For Hall Motor

SKU
MD-00640
-11%
Special Price PKR 2,350.00 was PKR 2,650.00
In stock
Don't Miss Out! This promotion will expires in
Sold items
8/13 Sold
Brushless Motor Controller Driver Board 500W (DC 12V-36V) For Hall Motor
  • Buy 50 for PKR 2,252.50 each and save 4%

FEATURES:

  1. DC brushless motor driver board.
  2. Operating voltage: DC 12V to 36V; operating current ≤15A.
  3. With speed regulation function, 0.1V-5V speed voltage.
  4. Stall protection, over-current protection, enable control, steering control and speed control signal.

SPECIFICATIONS:

  1. Operating Voltage: DC12-36V
  2. Operating Current: ≤15A
  3. Drive Power: ≤500W
  4. Speed Voltage: 0.1V-5V
  5. Operating Temperature: -40~85°C
  6. Humidity: ≤90%RH
  7. Stall Protection: Yes
  8. Enable Control: Yes
  9. Over-current Protection: Yes
  10. Steering Control: Yes
  11. Speed Control Signal: Yes

PIN CONFIGURATIONS:

Power terminal OUT:

  • VCC (positive power supply)
  • GND (negative one)
  • MC (motor phases W)
  • MB (motor phases V)
  • MA (motor phases U)

SET for the control side:

  • GND  control terminal ground
  • VR   the governor end 0-5V(corresponding to 10% of motor speed - 100%)
  • ZF   reversing control(connected to 5V or ground can change the motor rotation direction)
  • M   tachometer pulse output(depending on the number of motor poles corresponding to the number of pulses per revolution of the output number)
  • EL  enable control terminal(connected to 5V or ground running then 5V, grounding the motor stops)

HALL for the Hall terminals:

  • 5V, Hall power positive
  • Ha, Hall signal
  • Hb, Hall signal
  • Hc, Hall signal
  • GND, Hall negative
Control terminal for SET
  • The motor speed control wiring methods:Available potentiometer system speed can also be controlled by MCU Controlwhen the potentiometer control wiring, the potentiometer middle pin is connected to VR speed portpotentiometer connected to both ends of 5V and GND terminal voltage more high speed faster.
Hall Signal inputs for Hall:
  • Wiring diagram is shown, one corresponding to the HA, HB, HC and on the motor5V power supply connected to the motor Hall signals positiveGND power supply negative signal to motor Hall.
  • Note:Due to different motor manufacturers to make the Hall of Hall line order does not necessairly follow the line on the board to match the sequenceneed to be adjusted, please parents who pay atteneion.If  the line sequence is wrong, does not boot properly, current, or start other phenomena not open, forced to use the drive plate will burn.

PACKAGE INCLUDES:

  1. 1 X  Brushless Motor Controller Driver Board 500W (DC 12V-36V) For Hall Motor
Part Number NA
Weight 0.0200
Manufacturer Made in China
Voltage (Min) 12v
Voltage (Max) 36V
Output Voltage NA
Power 500W
Current (A) 13m
Frequency NA
Load Cell (kg) NA
Output Type Digital
Range NA
Temperature Range (Min) -40°C
Temperature Range (Max) 85°C
Operating System NA
Baud Rate NA
Interface NA
Num of Pin's NA
Diameter NA
Size (mm) NA
Only registered users can write reviews. Please Sign in or create an account